can0 0E094021#001C # "B&M: I'm powering on" can0 0E094021#001E # "B&M: I'm working correctly" can0 0E094021#001A # "B&M: I'm going to sleep" When turning off the key, the Body Computer asks the
The mechanic should then check the wiring connected to the switch and change it if necessary. When the switch has been replaced, the mechanic should make sure that both the brake lights and the cruise control system are working properly. To check the speed sensor, the mechanic will have to get underneath the vehicle.
I retro fitted CC on my 2011 Ducato with the same 2.2 engine. I had the connector on my steering column, and the switches on my brake and clutch pedals. It was a 45 minute job, and works a treat. You will need to reset the learnt functions on the ECU, or disconnect the battery while fitting, so the ECU relearn CC is fitted.
Norfolk. Mar 19, 2011. #2. Fuel senders usually work on the principle of varying resistance as the level drops & one end of the resistance is connected to earth. If you can work out which wire is which, you could replicate full/empty deflections on the gauge by earthing/open circuiting the wire which runs to the gauge.
My Fiat Stilo JTD 2005 was working perfectly until my battery went low and i had to use a charger booster to start it, now i have lost my power steering and the warning light is on. Ive checked fuses f02 and f24 under the bonnet are there any others to check or have i damaged the pas ecu? I
With an adaptive cruise control system the car tries to maintain your chosen speed, but will also keep a safe distance to the car in front. If the vehicle ahead slows down or someone cuts into your lane, the car eases off the accelerator or uses the brakes to slow down and keep an appropriate distance. Often you can tell the system whether you
. 754 535 533 384 203 28 239 264
fiat ducato cruise control not working
